










AB1 rods are individually built in Italy with blanks developed for each model rather than taken from a standard catalogue. Each blank is tested under load, and the finished equipment is assessed both in the laboratory and at sea. The construction combines carbon fibres and a polymer matrix, with fibre direction and layering chosen to obtain the required mechanical properties. Epoxy resins provide adhesion, chemical resistance and dimensional stability, while unidirectional fabrics place reinforcement where it is needed. AB1 manufactures its own structural carbon components within its production chain. Carbon butts and reel seats are designed to work with the flex of the blank while allowing practical dismantling where specified. Full Floating roller guides, on models equipped with them, follow the curve of the blank and are suitable for monofilament and braided line. AB1 consultants, engineers and rod builders can develop personalised equipment to suit an angler’s technical and finish requirements. Consult the model table for the components, dimensions and ratings of the version offered.
| Code | Model | Length | Weight | Sections | Guides | Casting weight |
|---|---|---|---|---|---|---|
| 201631 | AB1 Spinning Tuna Game ST1 | 2,32 m | 500 gr | Off-Set | Fuji SiC | 60-120 gr |
| 201632 | AB1 Spinning Tuna Game ST2 | 2,32 m | 500 gr | Off-Set | Fuji SiC | 80-140 gr |
| 202283 | AB1 Spinning Tuna Game ST1 | 2,32 m | 540 gr | Off-Set | Fuji SiC | 180-240 gr |